I had always associated Rode with quality, I’ve used their products before and always been very happy with them. However I find myself sadly disappointed with the quality of my recently purchased Rode SmartLav lavalier microphone. They advertise it as “a professional-grade wearable microphone” but I found it far from that.
The first thing I noticed was a physical problem, the foam cover / windshield was not properly attached to its frame. That got sorted by fully removing the cover and then the application of some superglue to re-attach it.
The microphone did come with a tie-clip which does quite a good job of holding the device and keeping the cable secure. The microphone itself is quite small, somewhat thicker than a toothpick, a lot thinner than a pencil. Assuming you could route the cable out of sight then it could go totally unnoticed if attached to the side of a monitor or to one side of a desk. Its omnidirectional pick-up pattern means it does not have to be pointing at the speaker in order to pick up speech.
The device is advertised as a smartphone device, I did try plugging it into my Zoom H1 recorder and also my video camera but (as expected) it didn’t work with either. I’ve tried it with three different phones. Using a Nokia Lumia 520 it gave an audio file that sounded a bit wooly with a loss of upper end frequencies. Using a Samsung Galaxy Note 2 gave a very tinny sound with loss at both the lower and upper frequencies. My iPhone gave the best overall sound in terms of frequency response however I still class it as ‘poor’ and far from the ‘professional-grade’ that Rode claim. There was also a noticeable background hiss all the way through and an intermittent crackle just to add to the distraction.
The one area where it did perform better than other microphones I’ve used is outside in that it picked up less wind noise than most. This does not, however, compensate for its overall poor quality of performance.
Sorry Rode, the phrase “could do better” springs to mind.
I’ve had my Rode Videomic Pro now for around the last two and a half years.
It was bought to give my Panasonic GH2 an improved sound quality when I was out and about videoing. My previous video device, a Canon HF100 has a non-standard hot shoe / accessory slot, so for that I had to get the Canon microphone especially for that camera, which of course was incompatible with my GH2. However I must give Canon their due, it’s a great microphone and did everything that I asked or expected from it.
This Videomic Pro has also been a great device. Although I don’t use it that often it has still suffered a fair amount of misuse and abuse, lived in holdalls and generally travelled around with me, but has always done the business when needed. It has been a bit of an irritation in that the rubber strips which provide the sound and vibration isolation between the microphone itself and its frame often detach themselves from their mounting positions, but I can live with that. As a video camera microphone I like it and I also often put it onto a small tripod and use it as a desktop mic. In this set-up sometimes feeding it directly into my camera, sometimes feeding it into my Zoom H1 and use the Zoom to record the audio.
Its one failure has been out in windy conditions. My Canon mic with its dead cat windshield handled windy conditions really well. I got the Rode made windshield for this Videomic Pro assuming that getting the proper branded item would give me good performance, however I’ve been very disappointed with its abilities to reduce wind noise. Where the microphone was money well spent, this Rode dead cat windshield was a total waste. A shame as Rode usually produce good products. I’ll just have to look elsewhere for a windshield.
Last Christmas I was given a present of a Belkin LiveAction microphone, so I thought I’d give it the once over.
On the box it stated that it was for iPhone / iPad type devices, however it uses the standard jack plug that’s common across most devices. It worked without any problems on the two different Samsung phones I have.
It’s about 12 cm / 4.75 inches long, so not that large, but is quite big compared to the size of a phone. If plugged into the phone and you’re using the camera that facing the way the microphone is pointing, then end of the mic may come into view. (Just something to be aware of.)
Once plugged in, there is a small knob to turn that helps to secure the device to the phone. On the side there is a three position switch. Off, close-up directional, long distance ‘super-directional’. It uses a standard AAA size battery.
Over the years, phone manufacturers have spent a lot of time, money and effort in improving their internal microphones. Under standard indoor conditions I didn’t find any huge advantage to using the Belkin. Where it really did come into play was outside. Using its standard directional setting it picked up my voice quite nicely while cutting out (or at least reducing to an acceptable level) most of the other background sounds. At one time I was standing beside a busy road where the level of traffic noise was such that if I was talking to somebody standing beside me I’d have had to shout, however the Belkin picked up my speech nicely. I can see this having some potential in a gig or live event type situation where you want the sound from the stage while minimising the noise from the crowd beside you.
Using it switched to its super-directional mode it did pick up speech from quite a few metres / yards away. The quality of sound was not particularly good, however I’d rather have some sound that may be poor but I can work with that no sound at all! I can’t see myself using it in this mode very much, though I guess it’s handy to have there.
Overall I rather like it. With phone video quality improving more and more people are using this function when out and about, and under difficult conditions this Belkin does do a better job than the phone’s internal microphone. It does however still pick up wind noise, I must look out for a windshield / dead cat screen for it.